Editorial desk
TailscaleGuide Editorial
The editorial desk that publishes TailscaleGuide. It is a byline for the site's editorial process, not a person, and this page carries no author biography because there is no individual author to describe.
How this desk works
- Articles are researched from primary sources: vendor and project documentation, published standards and specifications, release notes, advisories, and measurements published by the people who took them.
- Drafts are produced with AI assistance and then edited against those same sources before publication.
- Nothing published here claims hands-on lab testing, benchmarking, or first-hand measurement. Where a figure comes from a datasheet or someone else's test, the article names the source.
- Corrections go to hello@tailscaleguide.com and are made on the affected page. Funding is set out on the disclosure page.
Posts (7)
- Comparisons
Headscale vs Tailscale Explained: What Actually Differs
Headscale replaces one Tailscale component: the control server. What that buys you, the three features it does not implement, and where the pricing flips.
- Networking
Tailscale Subnet Router Configuration: Routes, ACLs, Tests
Advertise LAN routes, approve them with autoApprovers, scope access with grants, and handle the SNAT, MTU and overlapping-subnet traps before they bite.
- Networking
Tailscale Exit Node Setup: Linux, ACLs, VLANs, and Tests
Configure a Linux Tailscale exit node, approve it, scope access with grants, isolate it on a VLAN, and verify IPv4, IPv6, DNS, and tunnel performance.
- Comparisons
Tailscale vs ZeroTier vs NetBird: Mesh VPNs Compared
Self-host the control plane or not, L3 overlay or L2 bridge, policy file or console. The three questions that pick between Tailscale, ZeroTier and NetBird.
- Troubleshooting
Tailscale Slow? Fix DERP Relay and Throughput Issues
Fix slow Tailscale transfers by checking for a DERP relay, restoring direct UDP, then tuning Linux offload, CPU, MTU and subnet routers.
- Setup Guides
How to Set Up Tailscale: First Tailnet Guide
Install Tailscale, connect two devices, verify a direct path, configure MagicDNS, replace default allow-all access, and add subnet or exit routes.
- Networking
How a Tailscale Mesh VPN Works: Coordination, NAT and ACLs
Understand the tailnet model: WireGuard mesh tunnels, the coordination plane, DERP relays, identity-based ACLs, subnet routers and exit nodes.